Eberle — Instat 6 User Manual English
| Button | Symbol | Function | |--------|--------|----------| | 1 | Up arrow (▲) | Increase temperature / navigate menu up | | 2 | Down arrow (▼) | Decrease temperature / navigate menu down | | 3 | Clock (🕘) | Enter programming / time settings / confirm | | 4 | Auto/Manual (👤) | Switch between Auto (schedule) and Manual (permanent hold) | | 5 | On/Off (⏻) | Power / standby (frost protection remains active) |
| Code | Meaning | Solution | |------|---------|----------| | E1 | Internal sensor fault (open circuit) | Replace thermostat or sensor | | E2 | Internal sensor short circuit | Check for moisture/damage – replace unit | | E5 | External sensor fault (optional) | Check external sensor wiring or disable in P## | | Battery icon flashing | Backup battery low (clock will reset on power loss) | Replace CR2032 battery on PCB (requires opening unit) | | Flame symbol on but room cold | Relay stuck or wiring issue | Check voltage at terminal 2. If 0V, thermostat faulty. If 230V, boiler problem. | | Display blank | No power or internal fuse blown | Check circuit breaker, then test L-N voltage. | eberle instat 6 user manual english
A: Set P02 to a lower cycle time (e.g., 5 minutes) and ensure the thermostat is not near drafts or sunlight. | | Display blank | No power or
The Eberle Instat 6 uses screw terminals on the rear. Ensure correct wire gauge (0.5-2.5 mm² solid or stranded). Ensure correct wire gauge (0
