Remove the web. Press and hold the calibration button again for 5 seconds. The LED will flash three times, storing the "no web" value.
| LED Status (Red/Green) | Error Description | Likely Cause | | :--- | :--- | :--- | | | Normal operation | System ready. | | Slow Blink Green | Standby / No run signal | Missing interlock or run command input. | | Fast Blink Red | Sensor signal loss | The sensor is disconnected, dirty, or failed. | | Alternating Red/Green | Actuator overload | Motor draw exceeds 4 amps; mechanical bind or short circuit. | | Solid Red | Internal processor fault | Replace board or flash firmware. | Fife Csp-01 Manual
If you have a specific error code or a wiring question not covered here, locate your physical manual or download the PDF from Maxcess. Remember: When in doubt, check your sensor voltage and your ground connections—those two steps solve half of all CSP-01 mysteries. Disclaimer: This article is for informational purposes only. Always refer to the official Fife CSP-01 manual provided by Maxcess for specific safety, installation, and repair procedures. Model numbers and specifications are subject to change. Remove the web