Hot: Phison Ps225107ps2307

Early revisions of the PS2307 firmware had no temperature throttle. The controller would run at full speed until the NAND flash's solder joints began to reflow (soften). Later firmware added throttling, but it is reactive, not preventative. By the time the throttle kicks in, the drive is already dangerously hot.

Manufacturers save money by using thin plastic shells with no thermal pads. The controller has no path to dump heat into the outer casing. Instead, the heat stays trapped inside, cooking the NAND chips and the controller itself. Part 3: The Symptoms of an Overheating PS2307 You don’t need a thermometer to diagnose this. If your Kingston or Corsair drive exhibits the following, you are suffering from the classic "PS2307 hot" syndrome: phison ps225107ps2307 hot

A: No. Condensation will short-circuit the PCB. Let it air cool for 20 minutes. Early revisions of the PS2307 firmware had no

A: Absolutely. Move the PCB into a metal USB enclosure with a thermal pad. This drops temps by 20-30°C. By the time the throttle kicks in, the

The (often labeled on the chip as "PS2307") is a USB 3.0 to NAND flash controller. It is a single-chip solution designed for high-speed external storage. Launched in the mid-2010s, it became infamous for its aggressive performance tuning.

| Symptom | What is happening | | :--- | :--- | | after 2 minutes of copying a large video file. | Controller junction temp exceeds 80°C. | | Speed suddenly drops 90% (e.g., 100 MB/s → 10 MB/s). | Firmware thermal throttling activates. | | Windows "Code 43" or "USB Reset Failed" | Controller thermal shutdown causes a voltage sag, disconnecting the USB bus. | | Copy pauses for 10-20 seconds before resuming slowly. | NAND controller enters error recovery mode due to bit errors caused by heat. | | Drive disappears and reappears in File Explorer. | Thermal protection circuit tripped. |